Oracle Cloud Infrastructure Documentation

Reviewing Scan Settings

The default settings for scan frequency and the domain scan paths are per compartment. WebLogic Management uses these settings when scanning instances for new WebLogic domains and changes to existing domains.

Important

Pre-General Availability: 2024-10-11

The following legal notice applies to Oracle pre-GA releases. For copyright and other applicable notices, see Oracle Legal Notices.

Pre-General Availability Draft Documentation Notice

This documentation is in pre-General Availability status and is intended for demonstration and preliminary use only. It may not be specific to the hardware on which you are using the software. Oracle Corporation and its affiliates are not responsible for and expressly disclaim all warranties of any kind with respect to this documentation and will not be responsible for any loss, costs, or damages incurred due to the use of this documentation.

Review the scan settings to ensure they are correct and make any necessary changes. If you do not want all instances to use the same scan frequency and scan paths, you can override them at the managed instance level.

Using the Console

  1. Open the navigation menu and click Observability & Management. Under WebLogic Management, click Settings.
  2. Under Domain scan settings, view and verify the default settings:
    • WebLogic domain scan frequency (in hours): The number of hours WebLogic Management scans for WebLogic installations.
    • Domain home path(s): The file system scan paths.
  3. If you changed any of the default settings, click Save.

Using the API

Run the GetConfiguration operation to view the WebLogic domain discovery interval and search paths settings for the service.