1. From the Resource Type menu, Select Compute.
2. Accept the warning that indicates that all DR Plans will be deleted.
3. Select the instance to add from the list of instances.
4. Select or deselect Move instance on switchover or failover based on your requirement.

Non-Moving Instance

A non-moving instance is not moved from a DR Protection Group to its peer DR Protection Group during DR operations. You use non-moving instances in Active-Passive DR topologies where instances which comprise the application stack are pre-deployed in both regions and application software components. You start or stop these instances during DR operations in order to transition the service from one region to another.

The instances always stay in the region where you deploy them and do not transition from one DR Protection Group to another.

When you add an instance, a non-moving instance is added to the DR Protection Group. No additional member properties (configuration information) are required.

Provide the following configuration information:

In the Show advanced options, for a new non moving instance, the following options are available:

• In Settings, you can select Start and stop instance on failover/switchover.
• In Block volumes enter the following information:
  • Block volume in compartment: Select a compute instance.
    Note
    
    If the compute instance is a member of primary DR Protection Group, then select the block volume which is attached to that compute instance. If the compute instance is a member of the standby DR Protection Group, then select the block volume from the primary region.
  • (Optional) Volume attachment reference instance in compartment: Volume attachment reference is the peer compute instance used to get the attachment details.
    Note
    
    The value of the reference compute instance should always be from the peer region irrespective of the region (primary or standby).
  • (Optional) Mount point: The physical mount point used for mounting and unmounting.
  • Select the + Another block volume mapping to add other block volumes.
• In File systems enter the following information:
  • Export path: Export path for the file system. Example: </fs-export-path>
  • Mount point: Physical mount point for the file system. Example: </mnt/yourmountpoint>
  • Target in compartment: Select the mount target which is used to unmount on primary DRPG member and is then used to mount on the standby DRPG Member.
  • Select the + Another export mapping to add other file system.

• Click Add to add the compute instance to the DR Protection Group.