Higher Performance
The Higher Performance option is recommended for workloads with high I/O requirements that don't require the performance of the Ultra High Performance level.
This option provides a linear performance scale of 75 IOPS/GB up to a maximum of 50,000 IOPS per volume. Throughput scales at the rate 600 KB/s/GB up to a maximum of 680 MB/s per volume.
See Performance Details for Shapes for performance characteristics and instance details for Compute shapes.
Volume Size and Performance
The following table lists the Block Volume service's throughput and IOPS performance numbers based on volume size for this option. IOPS and KB/s performance scales linearly per GB volume size up to the service maximums so you can predictably calculate the performance numbers for a specific volume size. If you're trying to achieve certain performance targets for volumes configured to use the Higher Performance level, you can provision a minimum volume size using this table as a reference.
Bare metal instances that use in-transit encryption will see a maximum throughput of 540 MB/s at the Higher Performance level.
|
Volume Size |
Max Throughput (1 MB block size) |
Max Throughput (8 KB block size) |
Max IOPS (4 KB block size) |
|---|---|---|---|
| 50 GB | 30 MB/s | 30 MB/s | 3,750 |
| 100 GB | 60 MB/s | 60 MB/s | 7,500 |
| 200 GB | 120 MB/s | 120 MB/s | 15,000 |
| 400 GB | 240 MB/s | 240 MB/s | 30,000 |
| 600 GB | 360 MB/s | 360 MB/s | 45,000 |
| 700 GB | 420 MB/s | 420 MB/s | 50,000 |
| 800 GB | 480 MB/s | 480 MB/s | 50,000 |
| 1,024 GB | 614 MB/s | 614 MB/s | 50,000 |
| 1,200 GB - 32 TB | 680 MB/s | 680 MB/s | 50,000 |
Adjusting iSCSI Queue Depth for Higher Performance Volumes
The information in this section only applies to volumes attached to Linux instances. You do not need to make any adjustments to the iSCSI queue depth configuration to achieve higher performance for volumes attached to Windows instances.
When you configure the performance of an iSCSI-attached volume to the Higher Performance level from either the Balanced or Lower Cost performance levels, you need to adjust the iSCSI queue depth to achieve the performance maximum of 50,000 IOPS. The steps required to complete this depend on whether you are configuring the performance for a new volume attachment or an existing volume attachment.
Update /etc/iscsi/iscsid.conf to change the node.session.queue_depth from 32 to 128, as follows:
node.session.queue_depth = 128Run the following command to update the queue depth for the volume's iSCSI to 128:
iscsiadm -m node -T iqn.2015-12.com.oracleiaas:<IQN> -p <volume_IP> -o update -n node.session.queue_depth -v 128Run the following command to log out the iSCSI node:
iscsiadm -m node -T iqn.2015-12.com.oracleiaas:<IQN> -p <volume_IP> -uRun the following command to log the iSCSI node:
iscsiadm -m node -T iqn.2015-12.com.oracleiaas:<IQN> -p <volume_IP> -l- Reboot the instance.