Updating a DRG Attachment

• Console
• CLI
• API

• You can use the Console to update the display name of an attachment and advanced options including DRG route table, VCN route table, and VCN route type.

  1. Open the navigation menu  and select Networking. Under Customer connectivity, select Dynamic routing gateway.
  2. Under List Scope, select the compartment that contains the DRG with the attachment you want to update.
     The page updates to display only the resources in that compartment. If you're not sure which compartment to use, contact an administrator. For more information, see Access Control.
  3. Click the name of the DRG.
  4. Under Resources, click the type of attachment that you want to update:
     • VCN attachments
     • Virtual circuit attachments
     • IPSec tunnel attachments
     • Remote peering connection attachments
     • Cross-tenancy attachments
     • Loopback attachments

     If the attachment is in another compartment, select that compartment under List scope.

  5. Click the name of the attachment.
  6. Click Edit.
  7. (Optional) Change the display name of the attachment.
  8. (Optional) Click Show Advanced options and change the DRG route table, the VCN route table, or the VCN route type associated with the attachment.
  9. Click Save changes.

• Use the network drg-attachment update command and required parameters to update a DRG attachment's configuration details:

  Command

  CopyTry It

  oci network drg-attachment update  --drg-attachment-id ocid ... [OPTIONS]

  For a complete list of parameters and values for CLI commands, see the CLI Command Reference.

• Run the UpdateDrgAttachment operation to update a DRG attachment's configuration details.