WebLogic Management Service Configuration
After registering instances with WebLogic Management, review resources and settings, and configure patching.
Pre-General Availability: 2024-10-11
The following legal notice applies to Oracle pre-GA releases. For copyright and other applicable notices, see Oracle Legal Notices.
Pre-General Availability Draft Documentation Notice
This documentation is in pre-General Availability status and is intended for demonstration and preliminary use only. It may not be specific to the hardware on which you are using the software. Oracle Corporation and its affiliates are not responsible for and expressly disclaim all warranties of any kind with respect to this documentation and will not be responsible for any loss, costs, or damages incurred due to the use of this documentation.
- View service resources
- Become familiar with the Overview page where you can find a summary of all instances and domains in a compartment.
- Review default scan settings
- Verify that the scan frequency is suitable for the environment and the domain paths are correct.
- Review or set the server restart order
- Verify the order in which servers are restarted and patched.
- Define administrative credentials
- Select what type of WebLogic and Node Manager credentials WebLogic Management uses when starting and stopping WebLogic servers
- Configure domain patching
- Before you can patch a WebLogic domain, you must enable patching and set server lifecycle management. You can also enable patch rollback and set server timeout limit.